-
I use a 18v without any problems with mine.
Here is a recording from yesterday using it with my AER Compact 60. Recorded from AER direct output.
-
02-10-2020 09:02 AM
-
We need a proper engineer on here !
but this noise on the audio
with different power supplies which goes
away when using a battery .... thing
is something to do with the 'smoothing'
or otherwise on the DC power output ....
i.e. the output is wavy or spikey
(A battery naturally has a dead flat
smooth dc output)
but it we need a proper engineer on here !
-
My JR Barnyard isn't excessively noisy, it adds a small amount of hiss. I'm using a Boss PSA power supply. It's not as noisy as the hum from my large bobbin single coil pickups! That said my LED for the 'boost' side of the preamp is dead which is kind of annoying. That said it's the pedal I use the most. I'm not aware of any easily available alternative for getting octal style tones in a pedal.
-
That sounds great man !
and very CC sounding too
is that an es150 you solo'ed on there ?
-
I'm not talking about hiss, I'm talking about very loud buzzing and other noises. There is some hiss with any power source, and that's not the issue. I don't know what the cause is, I don't have a schematic of the pedal, and probably not the knowledge to find it if I did have one. My LED also burned out, and was replaced by Tavo with a very bright amber LED. It developed other problems at the same time the LED went, and it was fixed, with no explanation of what went wrong. He said it worked when he got it back, so I don't know. I'm not trying to bad-mouth the pedal, it's fine for what it is, but the noise issue is somewhat annoying, because I have to make sure to get the right power supply connected to it. If I get it right, no noise.
-
Hey, here's a great example of the Jr. Barnyard in action.
This was in Dènia, Spain on my Europe trip, guesting with my friend Enric Peidro's Quartet.
This is my 1937 ES-150 into the JRB into... a Bose L1 Compact speaker array. Crazy, right?
They had rented a Hot Rod Deluxe for me (since I've had such good luck using running the JRB into the efx return on those), but there wasn't really stage space at the first gig for the Deluxe and the Bose L1, which was supposed to be my acoustic amp. On a lark, I plugged the JRB into the Bose, and it sounded great, so we ended up using that for most of the tour to save room in the van.
-
Originally Posted by campusfive
I'm glad to report, that I got my Boss Power supply in the mail today, and with that one the pedal is finally quiet.
I still don't really know what's been going on there, but altogether I'm just happy to have it running now.
The noiselevel with my other power-supplies was that high, it would have made the pedal completely unuseble.
Now the pedal does a great Job with my acoustic amp, and I think I'll be able to put together a great acoustic/electric rig for my Swing Band.
Paul
-
Originally Posted by Webby
-
Originally Posted by clebergf
-
Hi-I took delivery of a Junior Barnyard yesterday. No matter what i do it doesn't seem to change the sound much. My Xotic Soul Driven seems to colour the tone better than this.
What am I doing wrong?
Doug
-
I found this which has the Junior Barnyard preamp plus reverb, by forum member Tim Lerch:
-
I don't understand what your point is FEP. It's just a video of Tim playing.
-
Originally Posted by Doug B
-
I believe the idea of these different preamp are to emulate old Tweed Fenders, Gibson amps and perhaps Rockabilly echo as well. Very nasally type of tone perhaps?
Also maybe they are direct to board type of application where they shine as well.
Just depends on what you are after, live or recording. There are great replica amps like Victoria Amps, Little Walter,etc. Or just buy an original?
-
Originally Posted by Doug B
"This pedal has a great combination of Nocturnes Jr. Barnyard pre- amp and a really cool and unique reverb section. Thanks to Tavo for making this great pedal. The Guitar is made by Barry at Grez Guitars, the Pickups are Lollar 50s Wind P90s. There is a full transcription in Notation and Tab available at timlerch.com"
So, the Jr. Barnyard sounds like that.
-
Originally Posted by pcjazz
I also am using a warmoth partscaster with walnut body and 3 Pete Biltof's Vintage Vibe Charlie Christian pickups. My other guitar is a stock Samick Greg Bennett Royale:
Amp is a 1974 Fender Princeton and a Fender Super Champ x2 run in stereo. I also tried with only one amp in mono.
-
Originally Posted by fep
Yes, I already knew how it was supposed to sound, but it doesn't. That's why I started this thread.
-
Originally Posted by jads57
-
On mine, there is a lot of boost, but both switches have to be engaged for that. Where are you setting the knobs? Below about 12 o'clock there isn't a lot of effect, and the amount depends a lot on the amp. Some amps are affected more than others, for reasons I don't really understand. I've pretty much quit using mine, and consider it wasted money. Jonathon Stout really likes his, so maybe it's my problem. But you should be getting a lot of boost with the left-hand knob turned up past noon, and the other switch engaged. You don't have to turn the right-hand knob up much to just get boost, but to get the semi-octal sounds you have to crank it past noon. At least that's how mine works, and it may or may not be representative.
-
Maybe, just maybe, it's not working properly?
-
The OP's may not be. Tavo says mine works as designed.
-
Originally Posted by Doug B
But as Hammer says, you may have a dud.
-
Originally Posted by sgosnell
and the amount depends a lot on the amp. Some amps are affected more than others, for reasons I don't really understand.
I've pretty much quit using mine, and consider it wasted money. Jonathon Stout really likes his, so maybe it's my problem. But you should be getting a lot of boost with the left-hand knob turned up past noon, and the other switch engaged. You don't have to turn the right-hand knob up much to just get boost, but to get the semi-octal sounds you have to crank it past noon. At least that's how mine works, and it may or may not be representative.
I'll keep the thread posted.
Cheers
DougLast edited by Doug B; 07-02-2020 at 07:08 PM.
-
Originally Posted by Hammertone
-
Originally Posted by pcjazz
The left hand button needs to be engaged for the pedal to do anything. The boost is on the right hand button.
But you are running into tube amps and my experience is mostly with clean solid state amps, where there is a very noticeable (and pleasant) effect on tone and response. I have a Koch tube head but did not find the JB to be much use in front of that.
But as Hammer says, you may have a dud.
Aer compact 60/4 $1,450.CAD
Today, 03:15 PM in For Sale