Is it possible to wire a Humbucker and a regular Tele Bridge pickup using a 4 way switch ? Im trying to get both series and parallel wiring on the neck pickup, both pickups together and lead single coil Tele.
Yep. I did that with Dimarzio Area Ts and with Wilde L280TN, both stacked humbuckers. No reason PAF style won't work. If there is a pick up cover it needs to be grounded separately. The diagrams ought to make things pretty clear.
although with a Dimarzio Area T (with cover) and then a Wilde L280TN (no cover). Haven't done it with a PAF style bucker, but I don't see why it wouldn't work with a 4 wire conductor. You might need to ground the cover.
One other ? Since I'm using both a Humbucker and a Single Coil what ohm pots should be used? I've seen diagrams with both 500k a d 250K as well as a mix.
Not sure which to go with?
Perhaps you could use 500k/250k dual ganged pots. I have a Strat with PAF buckers in the middle and bridge, SC in the neck and wired it so that there is a 250/500k volume pot, 250k tone pot for the neck and 500k tone for the buckers. I used one side of the switch as the 250k side and the other side for the 500k side- no jumper between the common terminals on the switch.
Digital procedures are currently recommended as a panacea for all sorts of problems that humanity is facing.
In fact, they offer fantastic opportunities in the areas of research, science and...
I had a Plek done at Gary Brawer's shop on a Godin Multiac Nylon.
It was no better after the Plek -- the tech who worked on it just prior did as good a job. It was pleked because of a buzzy...
If you follow the piano, the beats of the segments of the continuous repeating melody lines are phrased as segments that add up to 12 beats.
Starts repeating 12 note melody segments phrased...
Wired was my first, and still my favourite. Then I discovered Rough and Ready, Blow by Blow, and all the others.
https://youtu.be/vs_KgJlCd84?si=GFHMsEXto-Kbqvgx
I’ve played several plek’d guitars. Mileage may vary. There’s a steep learning curve for the machine’s operator. Fretwork and set-up done by a good tech who actually plays guitar him/herself feels...
Hi.
If I understand well you're asking for full hollowbody thinlines. ES330, and ES275 come to mind. While in the ES range. Apart from these I don't find others..
Gibson Thin line Guitar Models
Yesterday, 11:07 PM in Guitar, Amps & Gizmos