Is it possible to wire a Humbucker and a regular Tele Bridge pickup using a 4 way switch ? Im trying to get both series and parallel wiring on the neck pickup, both pickups together and lead single coil Tele.
Yep. I did that with Dimarzio Area Ts and with Wilde L280TN, both stacked humbuckers. No reason PAF style won't work. If there is a pick up cover it needs to be grounded separately. The diagrams ought to make things pretty clear.
although with a Dimarzio Area T (with cover) and then a Wilde L280TN (no cover). Haven't done it with a PAF style bucker, but I don't see why it wouldn't work with a 4 wire conductor. You might need to ground the cover.
One other ? Since I'm using both a Humbucker and a Single Coil what ohm pots should be used? I've seen diagrams with both 500k a d 250K as well as a mix.
Not sure which to go with?
Perhaps you could use 500k/250k dual ganged pots. I have a Strat with PAF buckers in the middle and bridge, SC in the neck and wired it so that there is a 250/500k volume pot, 250k tone pot for the neck and 500k tone for the buckers. I used one side of the switch as the 250k side and the other side for the 500k side- no jumper between the common terminals on the switch.
That could be a part of it, altho it's not that simple.... for example, the Swart is stiffer than my Hot Cat, but the Hot Cat is solid-state rectified. I suspect it has "sag resistors" which are...
I’m thinking the Fishman is not the best amp for this application and the line out flavored your tone.
A nice quality Deluxe style tube amp or a Princeton style amp would work great plus you have...
Idem; I got it into my head that the saddle lean (I thought I) observed couldn't be good for the tone, plus the slots were all quite deep to my taste (except for the 6th where the saddle had been...
That is what I have found too in other amps. EL34s do have a mid range focus and perhaps a tighter bass and later break up than a 6L6. Regardless it is fun to be able to swap power tubes without a...
Very true, but you could lose a fair amount of gain, and you mentioned that that is what you're going for. I've found that using the guitar's tone control takes the edge off very effectively while...
Well, "smoother" sounds good... sometimes a 5751 "takes the edge off" a 12AX7, which can be good for the high end part of the gain, making it less strident.
There was this thread at the Gear Page
Did Gibson make a mistake….. with Epiphones….. | Page 2 | The Gear Page
People seem quite pleased with those new Epis. What if they did a "new" Epi ES-175 ?
I didn’t think it was an improvement. The EL34 sounded fuller, punchier, livelier. I intend to try a 6L6 and a KT88 one day but am in no hurry because the EL34 sounds killer.
Some amps can take a few different power tubes without adjustment, because they are cathode-biased. My Swart AST can do this. I haven't tried it, as anything other than the stock 6V6s will be...
I concur. Your experience with the 12AT7 was pretty much the same as mine with the 4024 - it was just not crunchy enough for me. But what a sweet tone! As you suggest, it may be better to evaluate...
I wanted to point out that Monk's ballads are formidable af! Everyone knows Round Midnight, but he has a handful of others that are really good.
Crepuscule with Nellie
...
Playing live and getting the best sound from the...
Yesterday, 02:08 PM in Guitar, Amps & Gizmos